Water Heater Repair in Bridgeport, CT
Tell us what your water heater is doing, and a licensed contractor who covers Bridgeport will get in touch.
Tell us about the job
It takes about a minute.
What Bridgeport winters do to a water heater
Your water heater works harder from October through May, eight months a year, because the water coming into the tank is colder and it takes more to bring it up to temperature. That longer runtime wears on the heating element and thermostat in an electric tank, or the burner assembly in a gas one.
You notice it as water that takes longer to heat back up, or a tank that runs out sooner than it did in summer. Power matters too. Connecticut saw 20% of households lose power for at least a day in 2024, and a water heater that loses power in the middle of a heating cycle needs that power back before it can finish.
- 26°F
- the average winter night, and colder incoming water means longer heating
- 8 months
- October through May, the months homes here need heat
- 20%
- of Connecticut households lost power for a day or more in 2024, and a heater with an electric element or electric ignition stops without it
NOAA 1991–2020 monthly normals
A new water heater would cut about $100 a year off hot water for a typical Connecticut home.
Estimates for a typical Connecticut home, compared with an older unit built to the federal minimum, from EIA household energy data and Connecticut fuel prices. Your home will differ.
Repair makes sense when an element, thermostat or gas valve has failed.
Replacement makes sense when the tank itself is leaking.
- Why is my water heater leaking from the bottom?
- Most of the time this means the tank has rusted through from the inside and is failing. Once a tank starts leaking from the bottom, it does not seal back up. It could also be a loose drain valve or a fitting on the bottom of the tank, which a contractor can sometimes tighten or replace. But if the leak is coming from the tank itself, the water heater needs to be replaced, not repaired.
- Why won't the pilot light on my water heater stay lit?
- The most common cause is a worn out thermocouple or flame sensor, the part that senses the pilot flame and tells the gas valve to stay open. When it fails, the gas valve shuts off the pilot as a safety measure even though the flame is lit. A dirty pilot orifice or a draft near the pilot can cause the same thing. A contractor can test the thermocouple and replace it, which usually solves the problem.
- Can a tankless water heater be repaired?
- Yes, most tankless water heater problems are repairable. Common issues are a clogged flow sensor, a buildup of scale on the heat exchanger, an ignition failure, or an error code pointing to a specific sensor. A contractor can pull the error code and diagnose which part is causing it, then repair or replace that part rather than the whole unit.