Hot water pouring from a chrome faucet into a sink, surrounded by billowing steam.

Water Heater Repair in Stamford, CT

Tell us what your water heater is doing, and a licensed contractor who covers Stamford will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A chrome bath faucet pouring steaming hot water into a white freestanding bathtub.

Stamford winters push your water heater harder

Cold snaps that drop to 22°F push more cold groundwater through your water heater, and it has to work harder to bring it up to temperature. That extra strain shows up first in the heating element on an electric unit or the burner assembly on a gas one, and in the thermostat that tells them when to fire.

A fifth of Connecticut households lost power for at least a day in 2024. When the power comes back, an electric water heater switches back on by itself, but a gas unit with an electronic ignition may need someone to relight it. If your water runs lukewarm or won't heat at all after an outage, that's often where the problem sits.

22°F
the average winter night, and colder incoming water means longer heating
8 months
October through May, the months homes here need heat
20%
of Connecticut households lost power for a day or more in 2024, and a heater with an electric element or electric ignition stops without it
Isometric cutaway illustration of a single-story house with a dark shingled roof, showing interior rooms with furniture, a bathroom with tub and sink, and a cylindrical water heater connected to pipes and a vertical flue extending through the roof.
Your water heater works hardest from November through March.

NOAA 1991–2020 monthly normals

Why is my water heater leaking from the bottom?
Most often the tank itself has rusted through and is cracked from the inside out. Once that happens the tank cannot be sealed or patched, because the leak is a sign the steel has failed, not a loose fitting. It could also be the drain valve or a fitting on top that is dripping down the side and pooling at the bottom, which a plumber can check before assuming the tank is done. If the tank is the source, the water heater needs to be replaced.
Why won't the pilot light on my water heater stay lit?
The most common cause is a worn thermocouple, the small sensor that tells the gas valve the pilot is burning. When it wears out it shuts the gas off even though the flame is lit, so the pilot goes out again and again. A dirty pilot orifice or a draft blowing on the flame can cause the same thing. A plumber can test the thermocouple and clean or replace the parts causing it, and Connecticut requires that work be done by a licensed contractor.
Can a tankless water heater be repaired?
Yes, most problems with a tankless water heater are repairable. A clogged inlet filter, a buildup of scale on the heat exchanger, or a failed igniter are the usual culprits, and each can be cleaned or replaced without swapping out the whole unit. Error codes on the display panel point a technician to the specific part at fault. Replacement is usually only needed when the heat exchanger itself has failed.